Spack Spray
Reference : PT 0011
Polyurethane dispersion based paint that creates a “cement” effect finish. Particularly useful to touch-up cement coatings or renders. Can be applied to a wide range of building surfaces: wood, cement, plastic.
Spack Spray
Description of the PRO-Tech Spack Spray
PRO-Tech Spack Spray is a professional texturesimulatorbased on a unique PU dispersion, with which spack textures can be easily simulated. Ideal for retouching existing and new spack. PRO-Paint Spack Spray can be used on substrates common in construction such as; concrete, plasterboard, stucco, wood etc. The product has a high flow resistance and is excellent for painting on. Can be finished with all commonwall paints if desired. If desiredand necessary isolate the substratein advance with Pro-Paint stain sealer/ Insulation spray.
Properties of the PRO-Tech Spack Spray
- Colour: white
- Density at 20°C: 1.2
- Rapid drying
- Can be used in addition to a stain block paint when preparing a surface prior to painting.
Applications of the PRO-Tech Spack Spray
- Concrete
- Stucco
- Plasterboard
- Wood
Product references
- Easy and simple to use (spack texture without complicated equipment)
- Flow resistant on vertical surfaces
Physical and Chemical Properties
- Contents : 500 ML
- Base : PU-dispersion
- VOC content : 27 m/m %
- Solids content : 48 m/m %
- Colour : White
- Smell : light ammonia scent
- Use : depending on texture and use
- Approximately 500 ml per m2
- Relative density at 20°C : 1.2
- Storage/ Shelf life : 2 years
Specifications of the Spack Spray
Composition
Binders: polyurethane dispersion
Propellant: dimethyl ether
PT 0011
Data sheet
- Product type
- structured paint
- Application area
- Concrete, Woods, Plaster
- Volume
- 500 ml
- Packaging
- Box of 12 cans
- Application domain
- Preparion of the supports
Instructions for use
Before use, carefully read the directions on the packaging and act accordingly.
Remove all loose particles from the substrate. The substrate must be dry and free of grease. First isolate any stains in the substrate. Shake can well before and during use for 1 or 2 min. Mask or cover adjacent surfaces. By varying the layer thickness and the spraying distance compared to the surface, it is possible to spray both fine as well as course textures. Spack Spray can be used for covering, but also for light smattering, just apply texture after (after drying) the whole surface is painted over with wall paint. If several layers are required, it is recommended to leave a 10 minute Flash-off time between the layers. The ideal processing temperature is between 15 to 20°C. Use between 10 to 30°C, depending on the desiredtexture. The temperature of the can influences the texture. During spraying the can cools down and the texture gets courser. If preferred, you can slightly heat the can under lukewarmrunning waterdue towhich the texture becomes finer again (do not leave under a hot tap!). After use, clean the valve (turn aerosol upside down and press the nozzle for approximately 5 seconds), disassemble the nozzle and rinse under a tap. Caution! The propellant is highly flammable, no smoking, no open flames, no hotobjects (radiant heaters) during use. Provide adequate ventilation.
DANGEROUS. FOLLOW THE PRECAUTIONS.
Health and safety
CLP labelling with one pictogram.
DANGER
H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
Polyurethane dispersion based paint that creates a “cement” effect finish. Particularly useful to touch-up cement coatings or renders. Can be applied to a wide range of building surfaces: wood, cement, plastic.