PRO-Tech Glue and Bitumen Remover is designed to rapidly and safely remove residues of glue, polyurethane, tar, mastic, oil, Tectyl and glue, or any other sticky substances. Is also ideal for removing grease or resin and for cleaning tools. Non-corrosive and leaves no residue after use.
This product is no longer in stock
|Application domain||cleaning, care and maintenance|
|Product type||technical product - cleaner|
|Application area||Concrete, Bitumen, wood, plastic, plasterwork, metallic surface, synthetic|
|Packaging||Box of 12 cans|
PRO-Tech Glue and bitumen remover is specially developed for the quick and safe removal of sticker glue residue, bitumen, polyurethane, tar and glue-like polyurethane, sealants, oil, tectyl, adhesive tape residue andmanyother sticky residues. Also, it’s ideally suited for cleaning tools. To be used for removing wax and fats, but also for cleaning vehicles. A very powerful cleaning agent based on natural raw materials and which is economical to use.
Before use, carefully read the instructions on the packaging and act accordingly.
Spray Glue and bitumen remover on the soiledsurface. Leave on the soiled surface for a while and remove with a cloth. In case of resilient stains, repeat treatment until the desired result has been achieved. Should not be used on rubber and polystyrene. Always test the compatibility of the surface on a sample area! Does not remove hardened paint, polyurethane sealant and the like.
DANGEROUS. FOLLOW THE PRECAUTIONS.
CLP labelling with three pictograms.
H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H410 Very toxic to aquatic life with long lasting effects.
Shake thoroughly before use. Do not use at temperatures below 10°C. Do not use outside if there is a risk of rain or frost, or in full sun. Spray the solvent cleaner onto the surface to be cleaned. Leave to act for several minutes then remove with a cloth. If marks still remain, repeat until the desired result is obtained. Do not use on rubber or polystyrene. Before using, carry out a test on a small unobtrusive area of the surface to be cleaned to verify product compatibility. Will not remove hardened paint, polyurethane coatings and similar.