REFLECT LIGHT®: THE SAFETY SOLUTION FOR ZONES DIVED IN DARKNESS

The light from any beam (torch, vehicle headlights, etc) is reflected due to diffraction by the glass microbeads present in the clear varnish.

It provides a simple “safety” solution when there are natural obstacles or other specific risks that need to be seen in poor visibility, whether indoors or outside.

Properties of the REFLECT LIGHT Light reflective varnish

• Good durability over time: 6 to 12 months (depending on application surface and conditions).
  Can be applied to a wide range of surfaces (concrete, wood, asphalt, metal, stone, etc).
  (On plastic or painted surfaces, it is advisable to test beforehand to check compatibility).
• Application temperature: -15°C to 50°C.
• Apply one light coat. Good adhesion.
• Rapid drying: 5 min.
• Immediately becomes highly reflective at night, under a direct beam of light (30 m to 40 m).

DANGEROUS. FOLLOW THE PRECAUTIONS.

Specifications of the REFLECT LIGHT Retro-reflective varnish

Composition

Binder: acrylic.
Pigments: a specific blend of several types of specially treated glass microbeads, free from lead and cadmium.
Solvents: a complex mix free from chlorinated solvents and aromatic compounds (toluene, xylene, etc).
Propellant: a specific blend of isobutane and propane.

Application method

• Apply by hand or using our application equipment (hand gun, stencils). Vertical use (head-up).
• Before use : shake the aerosol vigorously and continue shaking for about fifteen seconds, even after having clearly heard the ball bearings, to ensure the paint is well-mixed (particularly the glass microbeads).
• Shake the aerosol regularly during use.
• During and after use: purge.
• Apply to a clean, dry surface.
• Apply very light even coats (successive lightly applied layers) approximately 10 cm to 20 cm from the surface to develop maximum reflectivity.
• In daylight it should be barely visible.
• It may be necessary to protect adjacent surfaces to prevent possible overspray (mist).
• The retro-reflective effect can be verified by holding a torch at eye-level and pointing the light beam directly at the painted surface, once it is dry.

Health and safety

Safety data sheets are available free of charge on the internet: www.quick-fds.com.
No paint mist or drips during use.
CLP labelling with a single pictogram.

DANGER

EC 927-241-2 DEAROMATIZED HYDROCARBONS
H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H336 May cause drowsiness or dizziness.
EUH066 Repeated exposure may cause skin dryness or cracking.P102 Keep out of reach of children.

Safety Data Sheet